When using Sketchup and placing enscape assets, I usually like to switch over to the select tool after placing an asset so I can then very quickly move/ rotate the asset. I do this via hotkey (spacebar). This causes a bugsplat about 7/10 times. Pretty awful for workflow, wondering if anybody else has this issue.
Reported soon after 4.0 was released: RE: Enscape 4.0 Released
I haven’t tried 401 yet but on its release I asked: RE: Enscape Service Pack 4.0.1 but I don’t think it was answered.
Thanks for your post @Rickyjlife ..
@Paul_Russam , please also check your e-mails for a further reply from me.
@Rickyjlife is there any chance you might be also using Skatter alongside? In any case please definitely submit a support report as detailed here just so we can check out your log files and so that can forward everything to our developers if necessary.
If you could ideally let me know *once said report has been submitted ( @Rickyjlife *) then that would be great. Thank you again in advance.