Try this as an approach when optimizing:
1. Put on a grey override and hide all scene lights, turn off GI. Turn on default lights in the global switches so you get nothing but a boring grey render in your viewport. Use your sample rate element and max adaptive dmc control until you get clean enough edges on your geometry and get a nice looking sample rate with red only where it’s needed.
2. Turn off default lights, turn on your scene lights and gi. Leave your grey override on and add in the raw lighting and raw global illumination passes. You know that your AA is probably in a good place now so lets not touch that. The sample rate element might go red again due to your lights or GI adding in noise but don’t touch your AA. Try instead adding in more subdivs to your light sources so in the controls of the lights themselves and in the subdivs of brute force GI if you’re using that. Change those settings until your raw light and raw GI are nice and clean (if you use irmap and LC instead of touching brute force then the raw gi is less important) and now when you go back to your sample rate then you should be back to having red only along the edges and blue everywhere else.
3. Turn off your material override and turn on the reflection, raw reflection, refraction and raw refraction elements. Again since these will likely be noisy, your sample rate element will go more red due to the aa sampler trying to clean up noisy materials. Again leave your AA as is, and gradually increase your material reflection / refraction settings until the render elements look clean and your sample rate has returned down to the usual red edge, blue everywhere else type of look.