Tweet
Hi there,
Hopefully I can explain this clearly.
I have a bone setup which is an ear. It has 5 bones (the ear is a long demon type ear). Each bone has its z rotation wired to the next bones z rotation. The base bones z rotation is then wired to the z position of a helper. Now when I move the helper the bones all bend nicely with thetop most ear bone bending the most.
I then create another helper and link the original helper to this new one. The new one then has a spring controller on it. So now when the spring controlled helper moves up and down it should drive the ear bend controller and the ears should bend, only they dont.
The ear controller moves up and down with the spring controller but the ears dont bend. If I move the ear controller manually the ears bend as they should ???!
Any ideas how I can do this....sorry about my long explanation
Hopefully I can explain this clearly.
I have a bone setup which is an ear. It has 5 bones (the ear is a long demon type ear). Each bone has its z rotation wired to the next bones z rotation. The base bones z rotation is then wired to the z position of a helper. Now when I move the helper the bones all bend nicely with thetop most ear bone bending the most.
I then create another helper and link the original helper to this new one. The new one then has a spring controller on it. So now when the spring controlled helper moves up and down it should drive the ear bend controller and the ears should bend, only they dont.
The ear controller moves up and down with the spring controller but the ears dont bend. If I move the ear controller manually the ears bend as they should ???!
Any ideas how I can do this....sorry about my long explanation
