Tweet
I'm working on a bunch of retail fixtures that have shelf attachments at various spacing (3", 2.5", 2.25"). I'll be needing to populate a lot of store with these fixtures and was wondering if it would be possible to limit the Z position of the shelves to a set "snap" spacing. I rarely work with constraint controllers and expressions, would these critters do the trick? If so any nudge in the right direction would be greatly appreciated.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
- Exciting News: Chaos acquires EvolveLAB = AI-Powered Design. To learn more, please visit this page!
- New! You can now log in to the forums with your chaos.com account as well as your forum account.
Comment