Driftwood upholstered chair

[eyepiz]

Does anyone know if the model is available to buy somewhere?...I'm used to drawing chairs but with this one I don't even know were to start!

I would appreciate if anyone could point me in the right direction.

Eric



http://www.restorationhardware.com/c...yId=cat3850044

[Neilg]

I'd use this - http://www.debrismaker.aarondabelow.com/v1/
To generate a bunch of branches (twigs), set up a material with multitexture to randomly switch barks/gamma between them and get to rotating/trimming/bending into place. Do a spline version first for a guide to figure out where you want the branches because otherwise you'll spend forever making tiny adjustments.

[eyepiz]

I have gone ahead and drawn up the models with Neilg's suggestions, Thanks! The problem I'm running into is texturing the braches, is there an easier way other than unwrapping each branch individually? I probably should have done this before I bent and twisted the heck out of them.

Right now I just have box map on them but they look kinda bad.