Tweet
If I open a multilayer EXR, create an adjustment layer, then expand the layers and run the contact sheet, the adjustment layer is separated out as another item in the contact sheet. It does not stay over the render pass that I intend it to stay over. Maybe there is a simple solution for this?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
- New! You can now log in to the forums with your chaos.com account as well as your forum account.
Comment