Tweet
I have a question. Well, I have tons of questions, but here is one of them:
Speaking here about ocean/wake/foam, etc...
Let's say I have an animation over 1500 frames.
1- you start to simulate.
2- at frame 280 you see that you have too much foam an stop simulation
3- you change foam threshold or amount (no changes on anything like liquid or dynamics)
4- you resimulate the 280 frames / it looks good
5- then, you restore (-preRender "phxfdBatchRestore("PhoenixFDSim1",280)" ) from frame 280 with new foam settings until the end
Is that possible ?
Speaking here about ocean/wake/foam, etc...
Let's say I have an animation over 1500 frames.
1- you start to simulate.
2- at frame 280 you see that you have too much foam an stop simulation
3- you change foam threshold or amount (no changes on anything like liquid or dynamics)
4- you resimulate the 280 frames / it looks good
5- then, you restore (-preRender "phxfdBatchRestore("PhoenixFDSim1",280)" ) from frame 280 with new foam settings until the end
Is that possible ?
Run a test sim in very very low res and if there are any issue, ping us.
Comment