Multiple Emitter Problem

[leehumphries]

I have a hot tub sim. Where i am trying to fire fluid from multiple jets of varying size.

My issue is that certain meshes dont allow fluid. I have checked the ID's / reset Xform etc

Just not liquid

Any ideas ?

[Svetlin.Nikolov]

Hey, could it be that these emitters are comparable in size to 1-2 grid voxels? They might be too small and thus are getting skipped by the voxelization. If moving the grid in respect to the mesh a little fixes some emitters and breaks others, this would be symptom of too large voxels and you would need to increase the grid resolution in order to fix it.

Cheers!

[leehumphries]

Thanks Svetlin - I have upped the grid resolution really high and still no fix. I will try and try a few more ideas.

Thankyou

[georgi.zhekov]

Hey,

If the the grid resolution is high enough, another thing to note is to make sure that your emitters are shelled (not a single-face geometry - they look like it in the screenshot).