Tweet
its nice you want to test the displacement. but it would just be easier to use a bump map in that case
-
---------------------------------------------------
MSN addresses are not for newbies or warez users to contact the pros and bug them with
stupid questions the forum can answer. -
I'm not sure Da_elf! Bump depend of the light, with displace you can see all of the perpendicular lines and it is not too long for render.=:-/
LaurentComment
-
How does it look without the displacement? Perhaps you have tiny bumps in your displacement map, which cause the noise.
Best regards,
VladoI only act like I know everything, Rogers.Comment
-
I'd agree. Adjust levels a LOT on your image. Come up with a joints-only image for displacement. Then use your current map as a bump map for the wood irregularities.sigpic
J. Scott Smith Visual Designs
FB Fan Page: http://www.facebook.com/jssvisualdesigns
http://www.linkedin.com/in/jscottsmith
https://jscottsmith.com/Comment
-
Yes Vlado I have found this: my displacement map must be without intermediate grey and there are tiny bump on that map.
thanks for reply
=:-/
LaurentComment
Comment