Vrayscatter Issues that won't get resolved

[danb4026]

I have the new Vrayscatter for Vray SP3. It has tons of problems, but I can't seem to get any help getting them fixed. As of now vrayscatter is useless. Anyone know of a fix?

I posted on their site and emailed, but cannot get an answer.

I attached a jpg of my vrayscatter dialog and the issues are obvious.

[duke2]

I'm going to go out on a limb here and say theres something wrong on your end. I'm willing to bet that if you deleted your configs it would work.

[dcullipher]

I had this as well. It was due to the license not being installed right. I redid my license and it works as expected now.

[danb4026]

ok....what configs file should i delete?

I will check into the license issue as well and see what happens.

[danb4026]

I also note that at the bottom of my vrayscatter dialog, it says Vrayscatter 2.04 Beta, even thought it is vrayscatter for sp3. Is this correct?

[Da_elf]

its scatter 2.04 FOR vray sp3. the version number of scatter doesnt need to be the same as that of vray

[danb4026]

I'm going to go out on a limb here and say theres something wrong on your end. I'm willing to bet that if you deleted your configs it would work.

I deleted the config file and now the "count" figure is a general number rather than a distance, which is a good start, but the proxies are still offsetting from the location they are supposed to be at.

I cant even get my proxies to render one they are scattered.