Z-Depth --- setting the range

[execpres]

I'm not that familiar with using Z-Depth but I know the Scanline renderer lets you set a Max and Min. Does Vray also allow this or does it use a more absolute form of z-depth information?

BTW, I know the z-depth doesn't display properly in the max vfb.

Thanks.

[vlado]

It doesn't display properly, but the values are correct. VRay supplies floating-point values for the z-depth to Max; any further processing (like converting the z-depth to 16 or 8 bit values) is done by Max...

Best regards,
Vlado

[execpres]

Ok.

Thx.