Tweet
Anyone using this yet? just try it but not exactly sure what its doing. Its a bit unstable at the moment.
-
might make more sense to join the thread where it is being discussed rather than start a new one on the same subject..... -
-
I know that it's a bit unstable, that's why we posted it for public preview - to try and figure out what would be the potential problems.
Best regards,
VladoI only act like I know everything, Rogers.Comment
-
tried embree with several of our typical archviz-scenes (lc+irr, vrayproxies, vrayfur, forestpro, 2500x1500 px typically running about 30 Minutes on single machine without spawners). Seems stable as it never crashed but more important it was about 10-15% slower. Machines were i7-3770k and i7-2600, both should support
MatthiasComment
-
It won't help with any of that stuff yet (proxies, fur, forest pro). Like you found out, it's likely to slow things down as there is some overhead to pass data to the original V-Ray rayserver for these things - although this slowdown can be fixed. If we implement it inside V-Ray itself, for proxies and dynamic geometry as well, it should be much faster.
Best regards,
VladoI only act like I know everything, Rogers.Comment
Comment