Tweet
I noticed that when using DR over the network it uses the list of DR machines from the machine that picks up the job rather than the machine that submits it. This means that if I want to control which machines are being used on such a job I have to go and change the list on a specific machine and then submit it to only that machine. It'd be nice if I could just submit it to the network and not have to worry about that.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
- New! You can now log in to the forums with your chaos.com account as well as your forum account.
Comment