lens effects again

[Jiri.Matys]

Hi,

I am just curious, when I enable Bloom and Glare, why Glare overrides the Bloom? When I put Glare to 100%, Bloom dissappear. I think this is bad, its really hard to make nice flares, when I can use only one effect. I tried to make Glare about 50-60% so Bloom stays visible, but both effects is barrely to see in some cases, mainly when I put larger size, its impossible to achieve results I want. And sometimes wanna make it more visible, 100% is not enough.

I know there were some complaining about lens effects. In latest version its interactive at least. But still do you plan some better support of this effects in feature versions?

[Jiri.Matys]

anyone? if its right that one effect block first one?

[asen.atanasov]

Hi,

currently lens effects weights work as follows:

- bloom weight is the blending between the bloomed RGB and the original RGB
- for disabled bloom, glare weight is the same
- for enabled bloom, glare weight is the blending between the result from the bloom effect only and the result from the glare effect only

We can think of different way to blend these effects.
We are working on better support in the future, so if you have any suggestions you can list them here.

Best regards,
Asen

[Alan Iglesias]

Hi,

I am just curious, when I enable Bloom and Glare, why Glare overrides the Bloom? When I put Glare to 100%, Bloom dissappear...

Yes, I have noticed this as well. Perhaps an option to completely separate the two would be a good thing...more control=always good!

-Alan