error light table

[comput_cg]

Hi!
I?m getting this error after reopening my scene!



Somehow the file gets damaged by putting a point light in the scene? And I can?t reopen the file (the file is empty when I say yes to the dialog box) unless I open the scene in safe mode and take out the point light...

Best regards
//A

[joe_b]

error light table

this problem is resolved. Sorry about that. In your build Direct lights and Point lights will cause this problem. I'll try to get a new build out in a day or two.

[comput_cg]

error light table

Thanks!

[Micha_cg]

error light table

... I have got this problem to, but with here I have shown light table and geometry table errors.

Do you have try to close Rhino and open your file again? If I remember me right, it has help me today.

Also, if you want to try to avoid a total lost, save a backup version of your file with "only geometry". This keep the model.

[comput_cg]

error light table

Thanks! Micha...

I can regain my geometry from the same file if I say NO to the dialog-box and open it a Rhino safe-mode. Then I can remove the light and then reload v-ray.

/a

[mousek]

error light table

Thx

[Micha_cg]

error light table

Thanks! Micha...

I can regain my geometry from the same file if I say NO to the dialog-box and open it a Rhino safe-mode. Then I can remove the light and then reload v-ray.

/a

Shock. I have try it today and it dosn't work. Only empty files of my current project. Beta testing is dangerous.

But, Rhino4 helps me. It open the files without any problem and than I have save the file in Rhino3 format. Anything is good again. Now I have deleted all pointlights in the file and never have got the problem again.