Toolbar position keeps resetting

[cneville]

Hi All,
The VRay toolbars keep resetting into two separate rows just below the main Rhino toolbar. I can move them around and even lock them and when I reopen Rhino they have reset to the same default position.

Also I've noticed that after a slow startup there is this message shown on the command line history (shown below).
File "C:\Program Files\Rhinoceros 5.0 WIP (64-bit)\Plug-Ins\VRayForRhino\Misc\VRayForRhinoV4_tb.rui" is already open.

Is something opening twice or is this notification normal each time the program Rhino and VRay starts?

Thanks,
chuck

[svetlozar.draganov]

Hello cneville

Thank you very much for the feedback.
We have the same behavior here - I am going to report this to our developers - although I am not so sure whether saving Vray windows positions is possible.

[-Keith]

Hey Chuck,

Try opening Rhino by right clicking and choosing "Run as administrator", move your bar to where you want it, then close and re-open Rhino.

That should fix it.

[renee81]

I am not the one who ask,but I had the same problem.it is now solved.

Thank You,

Renee

[-Keith]

No worries, I ran into the same issue myself a few weeks ago, I contacted McNeel through the normal customer channels and got great service from them. It has to do with the way Rhino stores its plugin information in the registry and needing the difference in permissions for writing there, any changes you make while an admin will stick.

[kostenurka]

same issue @ home. I'm like a monkey every time
will try out the admin way to see if will help

[anarchytecture]

Thanks for the tip. This has been annoying me forever!