Batch render did not remember which section active

[ValeroStudio]

Is this a known issue or am I not doing something correctly? When I batch render the view renders without the section on, if I render on its own it renders correctly.

I should mention that the scene before this has a section on and it does render correctly.

[georgi.georgiev]

Hi,

Could you please make sure that the section cuts are enabled for each specific scene? Note that V-Ray respects the state of the section plane/s for individual scenes. You can monitor the state through the V-Ray Asset Editor > Geometry tab as you cycle through the scenes.

Additionally, please be informed that you would have to create new section planes for each scene if a different position is required.

[ValeroStudio]

Confirmed that the sections are setup correctly. They do no render enabled with batch rendering.

[georgi.georgiev]

Could you share the project with us so we can investigate in detail? If this is alright, send us an archived copy (Extensions > V-Ray > Pack Project) via email or a file-sharing service of your choice to support@chaosgroup,com

Reference this forum thread as well, please!