Is it possible to render only one particular material ID in vray 5 for sketchup?

[manishpaul_simon]

Hi guys,
After I render an image, I realize that I need to change size of a particular material. And I'll have to re-render the entire image again or use a region render and render only that particular area of that image (which I made changes to) and then I can stitch it in photoshop.

But I would like to know if it's possible to render only a specific material using material ID (or anything else) instead of rendering the entire image?

I know this is possible in vray for 3ds max.

[nikoleta.garkova]

Hi manishpaul_simon

This is not yet possible, however, as it has been discussed in the past, our devs are looking into ways of implementing render mask in the future. I'll make a note about your post as well and will let you know when there are any updates on the matter.