Tweet
Good morning,
Iv'e two big problem with VRay RT. First, the installation to one node on our RF:
With the Master PC and one slave all is ok, but with one PC, after the VRayRT installation as a slave, If i try to register VRay-RT as a service, I've this error
"Impossible to load the application. The program configuration is not correct. Try again with a new installation can solve the problem"
What can I do?
Second, some problem with DR buckets. All work fine on single machine and with DR mode with VRay 1.5. But, with one DR machine, the VRay-Rt changes the "lightness".
All is setup with standard gamma, no LWF, nothing.
Some suggestion
Iv'e two big problem with VRay RT. First, the installation to one node on our RF:
With the Master PC and one slave all is ok, but with one PC, after the VRayRT installation as a slave, If i try to register VRay-RT as a service, I've this error
"Impossible to load the application. The program configuration is not correct. Try again with a new installation can solve the problem"
What can I do?
Second, some problem with DR buckets. All work fine on single machine and with DR mode with VRay 1.5. But, with one DR machine, the VRay-Rt changes the "lightness".
All is setup with standard gamma, no LWF, nothing.
Some suggestion
Comment