Am working on a project with 3D paper blowing in the wind.
I have made a piece of paper using pflow and skinned it to a piece of mesh. I am using a wind force to blow it around the scene.
All looks good so far but am finding it very difficult to control the position of the paper in camera frame just using the wind force.
I am trying to come up with a way that the wind blows the paper but the papers position is controlled by a spline or even better by the position of another particle event.
I have been following this excellent tutorial made by Kevin Harper on how to make 3D paper using Pflow.
http://www.youtube.com/watch?v=upsheC5vOk4
In the comment of his video
Hi Patrick, To link one to the other, have single particles in the speed by surface that are initially located in the center of each paper. Create a second glue that sticks the paper to the "driver" (speed by surface particles"). This may take some time to figure out but it is what I did for one section of the cloud and it works well.
I can't get it to work.
Not sure where to put the 2nd glue that sticks the paper to the driver, in the first event or in the 2nd event?
Anyone got any ideas?
I have made a piece of paper using pflow and skinned it to a piece of mesh. I am using a wind force to blow it around the scene.
All looks good so far but am finding it very difficult to control the position of the paper in camera frame just using the wind force.
I am trying to come up with a way that the wind blows the paper but the papers position is controlled by a spline or even better by the position of another particle event.
I have been following this excellent tutorial made by Kevin Harper on how to make 3D paper using Pflow.
http://www.youtube.com/watch?v=upsheC5vOk4
In the comment of his video
Hi Patrick, To link one to the other, have single particles in the speed by surface that are initially located in the center of each paper. Create a second glue that sticks the paper to the "driver" (speed by surface particles"). This may take some time to figure out but it is what I did for one section of the cloud and it works well.
I can't get it to work.
Not sure where to put the 2nd glue that sticks the paper to the driver, in the first event or in the 2nd event?
Anyone got any ideas?
Comment