Hello,
I usually use the sweep modifier to add base boards to my arch viz projects, however, usually after making some adjustments such as removing unwanted segments for doors and openings I get certain segments in a flipped orientation. Part of my floor boards are facing into the walls, this drive me nuts because I have to delete the "bad inverted" segments and create a new lines with a sweeps.
Its there a way to flip the orientation of a line? like flipping the face of an element?
I would appreciate any assistance.
Thanks,
Eric
I usually use the sweep modifier to add base boards to my arch viz projects, however, usually after making some adjustments such as removing unwanted segments for doors and openings I get certain segments in a flipped orientation. Part of my floor boards are facing into the walls, this drive me nuts because I have to delete the "bad inverted" segments and create a new lines with a sweeps.
Its there a way to flip the orientation of a line? like flipping the face of an element?
I would appreciate any assistance.
Thanks,
Eric
Comment