Question, creating dust, Phoenix-->Pflow?

[rhino]

Hi,
I was wondering is it possible to take a phoenix smoke simulation back to PFlow to render a small percentage of particles, eg using a smoke sim for dust or flying embers? Or is this something you can do in Phoenix without the need for Pflow?

[Ivaylo Katev]

phoenix registers PF operators for dragging,birth, and test of particles so it should be not a hard task.

[rhino]

Thanks, I'll look into it a bit more

[rhino]

Does the Phoenix PFlow Birth Operator support negative ranges? i.e. starting frame -500 etc. I often preroll sims or deal with animated sequences where this is needed.

[Ivaylo Katev]

yes it should support negative frames. do you have any problems with the negative frames, or just asking in case?

[rhino]

Just asking, I just often use negative ranges/preroll in realflow and pflow. Just thinking about workflow, just researching at the moment, there is not much info out there on phoenix atm.