I was testing the 0,1 value for fuel to get a water condensation effect on a cable in a scene.
The cable has a diameter of 1 cm and the grid was fairly highres and twice the width and height of the cable (can't say the settings as I'm not at my workstation)
So I had some nice dropplets forming but they were not on the surface but offset by maybe 0,5 cm
My question is: What value do I change to make the water stick to the surface from where it's been generated?
The cable has a diameter of 1 cm and the grid was fairly highres and twice the width and height of the cable (can't say the settings as I'm not at my workstation)
So I had some nice dropplets forming but they were not on the surface but offset by maybe 0,5 cm
My question is: What value do I change to make the water stick to the surface from where it's been generated?
Comment