Liscense error

[baw]

I installed 1.5r3 over the 1.47 version or whatever the older version was. It now says it an not obtain the liscense. what do I do.

thanks.

Brian

[vlado]

Did you choose software or hardware license during the installation? If you chose hardware installation, re-install V-Ray and choose "software" this time. It should fix it. Also, was your license on your local machine or somewhere else in the network?

Best regards,
Vlado

[baw]

I did software. And the liscense is on my local computer. Installed it again anywayy. After installing it says.... Invalid License:Bad node date. -18

[baw]

Can somebody please help me on this????????

I have sent three emails this past week to chaos trying to get this resolved. I can't use my Vray!

[baw]

Anybody??????????????

[Candelero]

Have you made any hardware changes on that working station...?

Try uninstalling 1.5 and see if 1.47 will get back ok.


Best regards,
nikki Candelero

[baw]

After reloading 1.47 it says invalid license, somthing about the license being to long. Then After pasting in the original license I was emailed for 1.47 I get...Invalid license:Bad node data. -18

[vlado]

In that case just email us to vray@chaosgroup.com and ask for a new code.

Best regards,
Vlado

[baw]

I have. I think 3 or 5 times over the last week and nobody responds.

[vlado]

In that case you can send me a private message with the email address which you used so that I can look it up.

[EDIT] Nevermind, I found it, please check your email. However, it looks like the computer configuration for which you have sent a license request is quite different from one for your old key.

Best regards,
Vlado