typical black blotches in light cache

[ene.xis]

did you set the lightcache to flytrough? if so, you need much more subdiv e.g 2000

best regards
themaxxer

did u check this?
if u set ur LC to 500 in flythrough mode ur definettely gonna have pretty low samples through out the flythrough!

[DaForce]

Yeah turn flythru on, set scale to world and put like 3000 subdivs.
I would suggest untick store direct light and change filter to fixed as well.

See if that helps.

[AWU]

this is the result with your values DaForce (we were already using World and flythrough) but i have switched the other options.



what do you think?

of course i have to make all the irr map calculation (for the 450 frames), otherwise there's no problem. If i make a 50 frame or less part it's ok. The problem comes when it's for all the animation.

Thanks!

ALex

[ene.xis]

i still think u need more samples in that LC...
personally i ve ditched flythroug mode on animations to calculate each nth frame in order to have more control over it...

[paulison]

did you try raising hemispherical subdivisions as several people have already suggested?. Also the frame looks very blurry so i think 40 is too high for interp samples. id also raise your max rate from -3 to at least -2.

Other than that, its most likely lightcache settings as mentioned I think (more subdivisions)

[DaForce]

Yeah I think it may just be the simple fact that your settings are too low.

[pengo]

3000 subds on LC with world in me always gives max crash for not enough memory (2GB on 4800x2 with double fast hdd in RAID)
COuld u please tell the reason ?
Is it better to raise up radius from 0.02meters to something like 0,.05 to avoid crashes?
thanks in advance

[pengo]

exucse me the question
is it the scene unit in mm?
That could be one of the cause as my friend told me to ask to u
bye