Blue Lights

[glorybound]

I have lights that are orange, but rendering out blue.




LC looks good

Turns blue during IRR pass and renders blue. However, rendering using BF is fine.

What is causing this?

[glorybound]

nobody? I am on a deadline... might be a bug.

[Syclone1]

I found I had the other file I mentioned earlier with me, going to isolate the problem light I had issues with and see if I can find the problem

[glorybound]

thanks! BF is working, so I'll go with that for now. BF is slower for me.

[Syclone1]

Well no luck trying to figure it out, I compared settings from 2 different files and its just raising more questions than answers. I thought the thread below might shed some light on it but now Im getting weird colouring and drastic differences in light between BF and IR with just a single V-Ray light and Store with IR is not enabled :S might try to look deeper in to it tonight as its really bugging me now lol.

http://forums.chaosgroup.com/showthr...as-Primary-now

thanks! BF is working, so I'll go with that for now. BF is slower for me.

[glorybound]

maybe a bug... odd the BF works and IRR doesn't.

[vlado]

I think it's just the prepass that is showing the wrong colors; the final render should be fine.

Best regards,
Vlado

[glorybound]

I'll have to lower some settings and see if it completes accuratly

[glorybound]

I closed it to work on some other things, opened it back up to see, and even the pre pass looks good now. So, something is goofy.

[glorybound]

Spoke too soon. The final render's lights were blue using IRR as the primary bounce; fine with BF.



It turned my tan shade material purple, too.

[werticus]

i had a broken scene once recently that would render bright orange everywhere... i thought it was a self illumination but i went through the mats with a fine comb and turned them all off and fixed nothing.

in the end i found that rendering with BRUTE + BRUTE or IR + BRUTE fixed it but any LC 2nd pass would not work.

[glorybound]

i had a broken scene once recently that would render bright orange everywhere... i thought it was a self illumination but i went through the mats with a fine comb and turned them all off and fixed nothing. in the end i found that rendering with BRUTE + BRUTE or IR + BRUTE fixed it but any LC 2nd pass would not work.

so, it's a known bug?

[vlado]

so, it's a known bug?

Not that I know of. Can you get me a scene for it?

Best regards,
Vlado

[glorybound]

It's the same scene as my "So Slow", posted yesterday.

Not that I know of. Can you get me a scene for it?

Best regards,
Vlado

[Raven]

As I said in the so slow thread, the problem is fixed if you desaturate the map in the translucency slot of the 2 sided mat.