Hi,
Really like the Vray Clipper due to its ease of use, however it does seem a little inflexible. For instance at the moment if you wish to make a pie cut using two clipper planes, instead of taking a slice out of a geometry it will leave the slice behind; so something like a termination point could be added so that it doesn't cut right through to infinity.
Alternatively adding a feature where you can pick a separate geometry as the cutting tool would be a more elegant solution, as it will allow you to make arbitrary cuts similar to what you get if you did render booleans using the Vray Distance Texture, but a lot less tedious to set up.
Having support for round edges for the clipped geometry would be great too!
Thanks,
Tak
Really like the Vray Clipper due to its ease of use, however it does seem a little inflexible. For instance at the moment if you wish to make a pie cut using two clipper planes, instead of taking a slice out of a geometry it will leave the slice behind; so something like a termination point could be added so that it doesn't cut right through to infinity.
Alternatively adding a feature where you can pick a separate geometry as the cutting tool would be a more elegant solution, as it will allow you to make arbitrary cuts similar to what you get if you did render booleans using the Vray Distance Texture, but a lot less tedious to set up.
Having support for round edges for the clipped geometry would be great too!
Thanks,
Tak
Comment