RGB tint cannot be rendered in vraydome map

[q976431]

If the map card slot in the vraydome light contains RGB tint Then it will not be rendered
This material node should be supported

Figure w001:
Color correction - RGB tint - vraybitmap (not rendered)
Figure w002:
Color correction - vraybitmap (everything is normal)

[hermit.crab]

There should be a warning that it isn't supported. It's written in the docs as well. Here's a workaround (screencap) - manipulate the VRayColor nodes to get the tint. Although, I think it would be simpler in PS.

[q976431]

There should be a warning that it isn't supported. It's written in the docs as well. Here's a workaround (screencap) - manipulate the VRayColor nodes to get the tint. Although, I think it would be simpler in PS.

I thought this was a bug that could be fixed. Sorry.
Your solution may be one of the alternatives, but it's still too complicated. RGB tint will be simpler
RGB tint is used to remove a certain color from HDR instead of adding a certain color. It can always achieve the desired effect quickly. If it is not particularly difficult, I hope it can be supported
Vantage could not achieve this before. Later, they completed this function. Maybe vraygpu can also support it
Because I switched back from vantage to render some scenes, I found that RGB tint was not supported.

[hermit.crab]

Just so you know, I've logged an improvement request (internal bug-tracker id: VGPU-5912) for RGB Tint's support on GPU.

[q976431]

Just so you know, I've logged an improvement request (internal bug-tracker id: VGPU-5912) for RGB Tint's support on GPU.

Thanks for your help