Problem with VrayVelocity 1.5Sp3a + Nuke 5.1

[noel_d3]

@Thorsten:

Could you motion blurred this image to better compare Nuke 2D Motion Blur and RSM vectors.

thx

[instinct]

There you go. Tweaked the Multiplier a little to be closer to the settings you used in your reference image.


Regards,
Thorsten

[mattwilsonVelatura]

I've gotten basically the same result. All I did in NUKE was recenter the input vectors @ .5 to zero(so the motion range is -.5 to .5), and then set the range from -1 to 1. You can stick a multiplier on after that, or use the motion vector mult to up the intensity. Of course, as stated before object occlusion is a problem, as is the background. I cheated in this on and recreated the BG to put in to test edge artifacts.