I can't understand why you are getting errors. Have you dropped the cpu:ram ratio to 1:1 and the started to push up the FSB? What memory have you got? I have used 800mhz ddr2 and it has worked a treat. If you have used 667mhz then it will severely restrict your oc ability.
Announcement
Collapse
No announcement yet.
NEW Benchmark scene (Max 8 Vray RC3 required)
Collapse
X
-
Yeah im using ddr2 800mhz - 8 gig of it ... rated for 5,6,6,18 at this speed
or it can do 4,5,5,15 at 667.
I'm not sure what to set in the bios regarding ram speeds and such - they confuse me, dont i want to set the ram to 667 and the push up the bus speed (and there by push up the ram and cpu speed together but with the ram starting underclocked so it wont crash?)WerT
www.dvstudios.com.au
Comment
-
okay i think i have it figured out - i didnt have enough volts going to the cpu to not give errors
i just put it up a notch and its stable now and no temp change either... so im going to work up the speeds and the volts until it starts to get hot.
3.113ghz 50c under load @1.425v so far
stable for 15mins under prime95 (yeah i know thats not totally tested, ill test over night when i've settled on a speed)
update - 3.240ghz 57c under load @1.525v - getting hot really and its a cold night - I've ordered a top end CPU water block as i feel the standard one isnt such a great design.
i have a question for you - since the ram is running at 720mhz and not 800mhz its made for- would that mean that the ram voltage would be fine at stock levels?WerT
www.dvstudios.com.au
Comment
-
The Peltiers modules clearly show condensation, but since my internal circuit is allways at a litle higher temp than the ambient, there is no risk of condensation inside my case.
This is just a test to see if it works ...
I will post the temps unde full load of the quad cores later.
Comment
-
-
we've gone way off topic: so without further ado:
my benchmarks
2:24s on the new pc in rc3
and 1:53s on the whole farm rc3
and
1:45s on the new pc on rc4
and 1:17s on whole farm rc4WerT
www.dvstudios.com.au
Comment
-
-
I did a test render with RC3 and V1.5 (now available in support section - requires dongle).
These are the results side by side. There are obviously some speed improvements in 1.5. Chaosgroup rule.
----------------------------------
Jonathan Baginski
3D Visualisation Specialist
Brisbane Australia
----------------------------------
Comment
Comment